United Process Versapro Podręcznik Użytkownika Pobierz pdf (Strona 20)

20 Important Product Information

GFK-1671P

34200

Error 502 comes up while validating projects with motion & local logic blocks

Details: Few VersaPro projects, which have valid motion and local logic blocks included threw

error 502 during validation.

Resolution: VersaPro 2.04 will not report this error for valid case.

34306

The font of print out increase in size from the second page onwards

Details: There were few instances where first page prints out correctly but from second page

onwards the font increases in size and cannot be read.

Resolution: This issue is fixed in VersaPro 2.04.

34362

Moving a CMM module in a 9070 destroys all EGD information associated

Details: Configure a CMM in a 9070 that has EGD information associated with it (exchanges

that use that CMM module) and move that CMM card in the hardware configuration, it erases

all EGD exchanges associated with it.

Resolution: EGD exchanges will not get deleted in VersaPro 2.04 after moving CMM to a

different slot.

35054

Not possible to enter negative constant to an input parameter of C block

Details: When we try to give negative constant as C block parameter an error was given as

"Constant Out of Range"..

Resolution: VersaPro 2.04 allows negative constant on C blocks.

35308

Run Mode Store of C Blocks is apparently not supported for the 90-70

Details: Run Mode Store of C Blocks is apparently not supported for the 90-70. The Message

Pops up and asks if you want to do a Stopped Mode Store. If you say Yes, it appears to

perform a Run Mode Store.

Resolution: In VersaPro 2.04, modified the check for C blocks during RMS to only ask about

stopped mode store if the PLC does not support bumpless RMS of C blocks.

35710

Maximum value for position offset for few APU functions is wrong

Details: Max value for Position offset value is 255 irrespective of APU function configured.

Resolution: This has been corrected in VersaPro 2.04. Max value varies depending upon APU

function configured.

36054

Save message box comes up for Variable Tables even when there are no modifications

Details: When you open projects created in earlier versions of VersaPro and close project

without any modifications. You will still receive a message to save variable tables.

Resolution: VersaPro 2.04 will not pop up this message in this type of scenarios.

39374

_Main.dec is not equal even though logic is equal

Details: Above problem is seen when we store logic, which has either BIT_SEQ or

SHFR_WORD function with ST set to either %M or %Q.

Resolution: This issue is fixed in VersaPro 2.04.

40448

No confirmation dialog when deleting an exchange

Resolution: VersaPro 2.04 will pop up a dialog to confirm the deletion of exchange.

40503

Moving CMM742 module and adding a module in that slot destroys EGD

Details: Configure EGD exchanges for CMM742 and move the module to another slot. Now,

add any module to the slot where CMM742 was previously present. EGD exchanges get

deleted.

Resolution: This issue has been fixed in VersaPro 2.04.

40590

“Output enable” parameter for GBI002 is not working properly

Details: This parameter has been incorrectly linked to discrete input segment. Parameter

should be attached to output segments

Resolution: This issue is fixed in VersaPro 2.04.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

United Process Versapro Podręcznik Użytkownika Strona 20

Komentarze do niniejszej Instrukcji